OPERATION
13
Tennant 3000/3040/3050 (06--03)
7. Turn power switch on and begin cleaning
(Figure 6).
FOR SAFETY: When using machine, do not pull
cord around sharp edges or corners. Do not
stretch cord. Do not close doors on cord. Do not
unplug by pulling on cord. Keep cord away from
heated surfaces.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
FIG. 6
NOTE:
The vacuum motor is thermally protected.
When machine senses excessive motor overload, the
motor will automatically shut off and reset after motor
cools. Should this happen while operating, turn off
power switch, unplug power cord and inspect vacuum
hose and filters for obstructions.
8. Replace vacuum bag when two-thirds full
(See
“BAG FULL LINE” printed on paper bag)
. Be
certain to turn power switch off and to unplug
power cord from wall outlet before replacing bag.
When using optional cloth bag, be certain to shake
out excess dust and to inspect bag for tears.
9. Perform Daily Maintenance procedures after
operating machine.
MACHINE MAINTENANCE
To keep machine in good working condition, simply
follow machine’s recommended maintenance
procedures.
FOR SAFETY: Before leaving or servicing
machine, unplug cord from wall outlet.
1. Replace vacuum bag after each use or as needed.
Do not reuse paper bags. Inspect cloth bag for
tears or holes. Replace if damaged.
2. Inspect power cord and cord grip for damage
before each use, replace if damaged. Wrap cord
neatly around cord hook after each use.
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it’s service
agent or a similarly qualified person in order to
avoid a hazard.
3. Remove and clean secondary filter bag after each
month of use. Replace filter when worn
(Figure 7).
FIG. 7
