www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
www.mcmelectronics.com
TM
TM
Page <6>
V1.0
28/03/16
AT90DH Soldering Station
User’s Manual
7. Sleeping mode setting
Sleeping power-off / power-on function and sleeping time can be set separately, which ensures energy saving and energy
consumption reducing.
Setting method:
Press “▲”and “▼” at the same time (picture 6), enter into programming mode (picture 7).
Under programming mode, press “2” (picture 10), or press”2” for 3 times continuously, then enter into sleeping setting
mode (picture 13-sleeping mode is off).
Under sleeping setting mode, press “▲” or “▼” (picture 5), input sleeping time (minute), then press “2” to save (picture 14,
sleeping time is 10 minutes).
If the sleeping mode is on and there is, no welding work or any operation in set time, the device will be in sleeping
(Mode2-no sleeping) and work in 200°C. If temperature is below 200°C, sleeping function won’t be activated.
Under sleeping mode, press any key to restart the device, and it can work under previous temperature.
Attention: Original mode- Sleeping status is off
8. Password-locked setting
This device is added with password-locked function for the convenience of equipment management for production line.
When the unit is locked, users can’t alter the settings without password.
Setting method:
8.1. Press “▲”and “▼” at the same time (picture 6), enter into programming mode (picture 7).
8.2. Under programming mode, press “3” (picture 15), enter into password-locked setting, current display is like
picture 16( password locked on). picture 17 ( password locked off)
8.3. Password setting:
When password is locked on, press “▲” or “▼” ( picture 3), input first password, and then press “3” to confirm,
like diagram 18.
When press “▲” or “▼”, input the password again, new password is OK, then press “3” to confirm and save.
New password is effected after restarting the device, any operation except reset password can’t be done
work now (picture 13).
