54Mbps Wireless Long Range Wireless AP
4.2.2 P2P Bridging Mode
Use two sets of TWL5401Ato link two wired LAN, to realize their connection
and sharing the resources between the two LANs.
Please click P2P Bridging Mode under Mode setting and enter the below
interface:
Figure 12
4.2.2.1 Function Introduction
1 SSID: To configure the SSID of the device.
2 Channel: Please select the wireless communication channel
(default as 6)
3 Show Signal: This function is used for Antenna And Signal
Scanner, please close the function when you use the device,
otherwise, the wireless connection can’t work probably.
4 MAC Address of the AP which is connected remotely: Please fill in
the MAC Address of the AP which is connected remotely (This
MAC Address can be obtained by scanning or you can fill in the
MAC Address by manually, at most 6 groups of MAC Addresses
are supported);
5 Security Setting: Please select the wireless encryption mode, P2P
Bridge Mode only support WEP mode (Note: When you select the
disable mode, security mode is invalid).
Please click “Finish” after setting.
4.2.2.2 Deployment
With the P2P Bridging Mode you can connect two wired LANs via
TWL5401A, without using wired cables. It is suitable for environment where
you require data connectivity but not easy to layout cables.
14
