Setting up naviPlay
To set up and use your naviPlay Stereo Headset, you first need to charge the Adapter and the
Remote for at least one hour. Use the included power supply to charge both naviPlay devices.
Step 1: Charge the naviPlay Adapter and Remote
Using the Dock Connector to iPod FireWire Cable, attach this cable to the connector on the back
of the naviPlay adapter. Then connect the naviPlay adapter to the included power supply and
plug it into an electrical outlet. Attach the additional charging connector to the naviPlay remote.
You can also charge the iPod at the same time by attaching your iPod to the adapter. See “Step
2: Attach iPod to naviPlay Adapter.”
The internal batteries will be about 80 percent charged after one hour, and fully charged after
four hours. While charging, each device's charge light will glow steady red until the charging is
complete, then switch off.
The status light will blink red when the naviPlay iPod Adapter or Remote needs to be recharged.
Quick Start
10
naviPlay Adapter
naviPlay Headset
Laptop
iPod USB Cable
or FireWire
USB Charging
Cable