TEMPUR BOXSPRING, User Manual

Page: 5 / 31

Leg assembly for beds with no headboard
7
Head-end
5
14 13 11
10
9
16
18
6
1 2
7 8
3 4
12
15
17
5
14 13 11
10
9
16
18
6
1 2
7 8
3 4
12
15
17
Double bed
Single bed
Support leg
5 6
14 13 12 11
10
9
15 16
17
18
7 8
1 2 3 4
Support leg
Chrome edge leg
Chrome curved leg
Chrome, oak, wenge,
walnut square leg
Floating bed (with no visible legs):
2 - 3 - 6 - 7
Bed with chrome edge legs:
2 - 3 - 9 - 10 - 12 - 13 - 14 - 15 - 17 - 18
Bed with chrome curved legs:
2 - 3 - 10 - 12 - 15 - 17
Bed with chrome, oak, wenge,
walnut square legs.
2 - 3 - 11 - 15
The leg assembly for the
foot end is the same as
showed on page 5 and 6.
Use the mounting part in
the head-end to keep the
two beds together.
8
Static bed, with or without headboard:
Flip the bed down and go to step 5.
3
How to operate the adjustable
feature on your bed?
How to use your remote control
a) Inset two AAA (1,5V) batteries. Ensure that the
batteries are inserted in the right direction (+/-).
b) Close the battery compartment lid.
Both the remote control and the adjustable bed should be operational.
If it is not operational, please follow the steps below:
How to sync your remote control with the
bed motor (for adjustable beds only)
To sync your remote control with the bed motor:
a) First set the remote control back to the factory settings. To do this,
press the buttons 1 3 and 5 simultaneously and keep them
pressed for approx 8 seconds.
b) Press button L on the dual drive for approx 1 second.
c) Then press the buttons 1 and 2 on the radio transmitter at the
same time for approx 10 seconds.
d) The head-end and foot-end will move briefly to confirm the sync
was successful.
How to enable two single beds to adjust simultaneously
To sync your remote control with the two bed motors:
a) Please follow the above steps a-d.
b) In addition, press button L on the second dual drive for approx
1 second.
c) Then press the buttons 1 and 2 on the remote control at the
same time for approx 10 seconds.
d) The head-end and foot-end of the second bed motor will
move briefly to confirm that the sync was successful.
3
1
5
2
4
6
Head-end