BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
ASSEMBLY
STEP
PRE-ATTACHED BOLTS AND WASHERS
LOWER HANDLEBAR
PRE-ATTACHED SET SCREWS
UPPER HANDLEBAR
F) Remove
PRE-ATTACHED BOLT & WASHERS
from
CONSOLE MAST.
G) Slide
LOWER HANDLEBARS
onto
CONSOLE MAST
and attach by re-inserting
PRE-ATTACHED SET SCREWS.
H) Slide
UPPER HANDLEBARS
onto
LOWER HANDLEBARS
. Secure
UPPER HANDLEBARS
to
LOWER HANDLEBARS
using
PRE-ATTACHED SET SCREWS
.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
PRE-INSTALLED
BOLT & WASHER
RESISTANCE
KNOB
TENSION WIRE
RESISTANCE
KNOB BRACKET
TENSION
CABLE
TOP KEY HOLE
BOTTOM KEY HOLE
NOTE:
There is NO hardware bag for this step. All hardware is pre-installed.
A) Pull
TENSION CABLE
out from square hole in console mast.
B) Turn
RESISTANCE KNOB
to highest resistance setting. Place the
TENSION WIRE
into the
BOTTOM KEY HOLE
on the
RESISTANCE KNOB BRACKET
.
C) While holding the
RESISTANCE KNOB BRACKET
, pull the
RESISTANCE KNOB
up to slide it into the
TOP KEY
HOLE
position on the
RESISTANCE KNOB BRACKET
.
D) Once the
TENSION WIRE
is in position, turn the
RESISTANCE KNOB
to the lowest resistance setting.
E) Slide
RESISTANCE KNOB & BRACKET
into the
CONSOLE MAST
and attach using
PRE-INSTALLED BOLT &
WASHER
.
STEPS A-E
STEPS F-H
910E ONL
Y
