Tempest Leader SMOKE 3, User Manual

Page: 13 / 24

13
7.1 Setting up
Fill the fluid tank with an approved LEADER fluid as shownon page 16.
7.2 Final checks
Before applying power to the machine, verify the following:
•
The machine is safely located or installed and meets the location requirements stated on
page 11.
•
The operator is familiar with, and able to comply with, the requirements for safe operation
listed on
page 4 .
•
The fluid is one of the Approved LEADER fluids listed under “Approved fluid types”
on page 16 .
•
The machine is electrically grounded (earthed).
•
The AC power distribution circuits and lines are adequately rated for the current load.
7.3 Turning on the power
Set the mains switch on the rear of the unit, to the
‘ON’ (I)
position.
The display will show HEAT .
When the display shows READY the unit is ready to produce smoke.
To obtain maximum output, wait another few minutes after the READY indication
is shown, as the machine continues to heat to full operating temperature and fog output is
reduced while the unit is heating up.
HEAT
READY 00%
READY 00%