Tempest Leader SMOKE 3, User Manual

Page: 11 / 24

11
5 QUICK START
If you are familiar with this type of product, this section will help to get you started quickly.
However, please also make the time to read the safety and servicing instructions in the remainder
of this manual.
5.1 Setting up
Locate the machine in a suitable area with nothing in front of the fog output.
Install approved LEADER fog fluid as shown on page 16.
Connect the machine to a suitably rated power source. The power requirements are:
LEADER Smoke 3 1200 W, 5.3 A / 240 V (EU)
1050 W, 8.75 A / 110 V
LEADER Smoke 5 2100 W, 9.2 A / 240 V (EU)
1800 W, 15 A / 110 V
Now set the mains switch on the rear of the unit, to the
‘ON’ (I)
position.
The display will show HEAT .
After about 6-8 minutes the display should show READY and the current programmed
output
level % .
5.2 Making fog
If you want to adjust the fog output level press the output up/down buttons
until the display shows the desired output level.
Press the Smoke button to begin fog production.
The unit will continue to produce fog until the button is pressed again or the fluid supply is
depleted
(whichever is sooner).
If no fog is produced the first time the unit is fired after a fluid out, it may be necessary to
prime the machine. Program the output to maximum power and fire the machine until fog
is emitted.
HEAT
READY 00%