Page 5
Operation
On/Off
Starting Operation
When the unit is turned off, press the [ON/OFF] button. The operation LED lights
and the system is turned on.
Bypass Operation
To activate the air conditioner outside any pre-set times, follow the instructions
inside the flap cover (or refer page 7).
Stopping Operation
When the unit is turned on, press the [ON/OFF] button. The operation LED light is
extinguished and the system is turned off.
Room Temperature Adjustment
Normally the display will show the current room temperature (not the preset
temperature). Set the temperature of your choice by pressing the Set Temp.
buttons, [
▲
] or [
▼
].
Each push will change the temperature by 1
°
C.
Temperature can be set within the range 16
°
C – 30
°
C.
During Fan mode the temperature can not be set.
Mode Selection
Press the [MODE] button to switch operation between Cool, Heat, Auto, Dry and
Fan. The display shows which mode is selected at any one time.
Cool
– If the room temperature is too warm, the air conditioner cools the room until
it reaches the set temperature.
Dry
– If the atmosphere in the room is very humid or damp, use this mode to both
reduce the humidity and cool until the room is near the set temperature.
Heat
– If the room temperature is too cool, the air conditioner warms the room until
it reaches the set temperature (Reverse Cycle systems only).
Auto
– The air conditioner will automatically cool or heat the room until it reaches
the set temperature (Reverse Cycle systems only).
Fan
– If the atmosphere in the room is stale, use this mode to circulate the air in
the room, without changing the overall room temperature.
Fan Speed Selection
Press [FAN] button to select Auto, High, Medium or Low speed.
Auto
– The TTS-11 will automatically select the most suitable fan speed to
maintain the set temperature.
High
,
Medium
,
Low
– A choice of three manually selected fan speeds are available.
Page 8
Remote Control (option)
OPERATION
MODE:
- Heat
- Auto
- Cool
- Dry
- Fan
AUTO
SWING
SLEEP
SIGNAL
CLOCK
& TIMER
FAN SPEED
Operation
A light will blink and a beep will sound when
the wall plaque receives a signal from the
hand held Infra Red Remote Control.
The IR Remote Control must be pointed
directly at the TTS-11 Wall Thermostat
plaque in order for its signal to be received.
ON/OFF
Press to toggle the air conditioner between
ON and OFF status.
ADJUST SET TEMPERATURE
Press
▲
or
▼
to increase or decrease the
desired room temperature.
Note: A temperature can not be set in
Fan mode.
MODE
Pressing this button will advance the mode
in the following sequence:
→
Heat
→
Auto
→
Cool
→
Dry
→
Fan
FAN
Pressing this button will advance the fan
speed as follows:
→
Low
→
Medium
→
High
→
Auto
Under
Fan mode, only Low, Medium and
High are available.
Under
Dry mode, fan speed will be
inhibited and will not be displayed.
AUTO