KCH-240
Hydraulic Cable Cutter
www.grupotemper.com
2
．
Description of the components
Code
Name
Function
1
Cutting head
For fix the cutting blade
2
Blade
For cutting
3
Active blade
Assist to cutting
4
Lock latch
For lock/unlock the cutting head
5
Retract lever
For release pressure
6
Pump handle
for operating
7
Fixed handle
for storing oil
OPERATING INSTRUCTIONS.
Please check carefully before operating. Make sure the tool is complete and has no damage
part.
Please do not knock any part of the tool, otherwise it is dangerous
for operator.
1. Open head and put into cable.
When the piston was fully retract, pull out the latch to open the head, put cable into head,
then close the head and lock it, insert the latch wholly into the tool. If the cable is short, it
can be put into head without opening it. Please see the illustration below.
The tool is not insulated, please do not use it on the live conductor
to avoid injury occurring.
2. Begin to cut.
Press down the handle and open the buckle to release the handle, keep pumping until the
material was cut. Press the retract lever to release the pressure manually. When the piston
and down blade retract fully, it means we have finished one cycle of cutting. Do the same
procedure for the next cutting. Please see the illustration below.
Do not put your fingers into the head of the tool during operating.
Your fingers could be pinched very severely.
3. AFTER CUTTING
If the tool is not used for a long time, please make sure the piston stay on its starting
position, count the accessories. Clear up the tool and paint the rustproof oil both to the tool
and accessories.
The tool will automatic stop after cutting off the material to avoid any accident.
