TEMA TELECOMUNICAZIONI
Paging Microphone Base for Announcements and Chime
MAS-AD696-BM-REV00EN
Page 9 of 10
5. CONNECTION AND PREPARATION OF THE MICROPHONE BASE
The AD696/BM microphone base is powered by the AD615/S system to which it must be directly connected. Insert
the 8-pole plug connector of the integral cable connected to AD696/BM into the black RJ45 socket on the AD615/S
module as clearly indicated in the photos below.
Now turn the base by laying it on one side, open and remove the flap located under the base to access the
compartment enclosing the control circuit board.
The board features programming dip-switches and two volume adjustment trimmers: one for adjusting the volume
of messages announced via the microphone and the other for adjusting the start warning tones message (Chime).
At the end of the adjustments or settings, replace the door in its seat.
Bridge for the type of
mounted microphone
(leave inserted)
Adjust the microphone
volume for
announcements
(clockwise increases)
Adjustment of the volume
of the chime signal at the
beginning of the message
(clockwise increases)
Four selectors to indicate
which chime signal must
be reproduced among
those present in the
system
(see appropriate table)
ON - OFF
