telylabs telyHD, Quick Start Manual

Page: 7 / 12

Get r
eady
Make a call
Mor
e info
4 Change the Input/Source on your TV
To use telyHD, you will need to switch
your TV or AV receiver’s input to match
the HDMI input used by your telyHD in
the previous step.
To change inputs, look for the Input/Source
button on your TV remote or AV receiver.
Press this button to cycle through the
inputs until you get to the HDMI input used
by telyHD. You may need to wait a couple
of seconds between each button press to
allow your TV to adjust.
You should now see the telyHD logo or
the Welcome Screen for the Guided Setup
on your TV.
Note: To return to watching TV, repeat the same process
described above. Cycle through the Input or Source settings
until you reach the correct one.
HD camera
telyHD button
& indicator LED
Camera on LED
Privacy shutter
Infrared (IR)
remote receiver
4 Noise-canceling microphones
to enhance audio quality
Fr
ont view
Ringer
Back view
SD card reader
USB port
Built-in Wi-Fi
Ethernet port
Mini HDMI port
Power port
telyHD
Guided Setup
Note: For the remainder of the setup
process you’ll need your telyHD remote.
After a few moments you should see a
screen similar to the following:
Follow the onscreen instructions to
configure your telyHD.
Connect via Wi-Fi
If you did not connect your telyHD using
an Ethernet cable, follow the instructions
in Guided Setup to add telyHD to your
home Wi-Fi network.
For more information on how to
use your remote, flip open this flap.
Speaker
Examples may not match your remote.
Setup