Telycam TLC-300-IP-20NDI, User Manual

Page: 9 / 40

7
IR REMOTE CONTROLLER
POWER
Under normal working mode, short press POWER key, to enter standby mode.
Press it again, the camera will do self-configuration, then go back to HOME position.
It will go to preset position if power on model has been set before.
FREEZE (Not Supported in USB)
Short press FREEZE key to freeze/ unfreeze the image.
IRT (IR Transfer/IR Pass)
Open / close the IR pass function. Once press the IRT key, the camera will receive and
Pass the IR remote control signal to the codec/terminal (via VISCA IN port).
SET 1~SET4 ADDRESS SETTING
Long press for 3seconds until the key light ON, to set camera address.
CAM1~CAM4 (CAMERA SELECTING)
Short press to select the relative camera.
NUMBER KEY (1-9)
Set preset: long press (3 seconds) the number key to set preset.
Run preset: Short press the number key to run preset.
CLR PRE (CLEAR PRESET)
CLR PRE+ number key: to clear the relative preset.
Long press to clear all preset.