56037002 - 5 - © 2007 Telular Corporation
LED Functions & Description
LED 1: Signal Strength LED 2: Operating Mode
LED 3: System Status
LED 3: STC LED Table
UL SUPPLEMENTAL LISTING:
The following programming and installation requirements must be met:
For commercial applications, the model TG9G0001 shall be secured inside the listed control
unit enclosure and only the antenna may protrude out of the enclosure. TNC jumper may be
used for mounting the antenna outside of the control unit.
For residential applications, the model TG9G0001 may be mounted in the same protected
room outside of the panel enclosure.
The TG-9 panel has been cross listed with the following panels. If connecting Telguard with a
cross listed panel please use the following chart for the wiring between the bell output of the
alarm panel and the Trip1 input of the Telguard.
TG-9 is for supplemental use only. For UL listed application, do not connect the trip input
zones 2 through 6.
Model
Bell polarity
Low = connect – to INPUT_1,
High = c to INPUT_1
Ademco Vista-20
High
Brinks B3000
High
GEM P1632
High
Bosch D7212GV2
High
DMP XR500
High
Napco F-8KIT1
High
DSC5020
Low
TABLE 1 – Zone 1 Bell Polarity
Note: the Telguard model TG-9 requires a minimum of 250ma during normal operating mode. Please
ensure you
do not exceed
the auxiliary current supply of the alarm panel.
Green Solid
Good Signal Strength
Green Flashing
Acceptable Signal Strength
Yellow Flashing
Weak Signal Strength
Red
No Signal Strength
Green All
OK
Green Flashing
FOTA in Progress
Yellow Flashing
Standby Mode (Shunt)
Red Flashing
STC
Red
No SIM Card Installed
One Flash, Pause
Power Failure
Four Flashes, Pause
No Cellular Service
Five Flashes, Pause
Fail To Communicate
Green
Registered and Enabled
Green flash
Transmitting Signal
Yellow
Awaiting Response
Red
Not Registered or Enabled
Red Flashing Failed Registration, NACK