SX6P SETUP
RUIM Card Installation (RUIM Model Only)
Consult your service provider to determine if your unit is a RUIM model. If so, your SX6P will
only be able to make emergency calls until you install a RUIM card. It will not receive calls or
allow non-emergency outgoing calls. For an explanation of how to configure your RUIM once
your SX6P is set up, see
RUIM Usage
(page 6).
1. Remove the power supply if it has already been connected. The power supply must be
removed whenever a RUIM Card is removed or installed.
2. Remove the RUIM compartment cover. -
see Figure 1
.
3. Open the RUIM compartment holder.
4. Line up the RUIM card with the arrow on the RUIM card holder -
see Figure 2.
5. Gently insert the RUIM card in the slot of the RUIM card holder.
6. Close the RUIM card holder.
NOTE:
Do not force the RUIM card holder shut. Make sure the RUIM card is aligned properly
with the directional arrow on the holder.
7. Reattach the RUIM compartment cover, closing it with the separate cover screw provided.
Install Batteries (Optional)
1. If necessary, remove the screw that may be holding the battery access door located on the
bottom of the unit -
see Figure 3
.
2. Press the battery access door tabs and remove the battery access door.
3. Install the Telular rechargeable battery pack into the battery pack area and connect wires.
4. Reinstall the battery access door using the screw -
see Figure 4
.
RUIM Compartment Cover
RUIM Card
Holder
RUIM Card
Figure 1 -
RUIM compartment cover.
Cover Screw
Figure 3 –
Battery access door.
Battery Access
Door Tab And
Screw
Figure 2 -
RUIM card installation.
WARNING!
Do not use batteries other than the included Telular battery pack with the SX6P.
Using any other batteries may result in fire and/or other damage to the unit.
!
Phonecell
®
SX6P CDMA
1
User Manual
Battery Access Door
Figure 4 -
Battery installation.
Battery Pack Area
