Inserting the batteries
Figure 3. Inserting the batteries.
AT1000 is autonomous device which uses two R14 (IEC 60086 standard) batteries. Batteries
used in this device are single charge Li based type and should have the following parameters:
•
Voltage: 3.6V
•
Nominal capacity:
5500mAh
•
Max pulse current not less than: 2000mA
Teltonika recommended batteries are available for sale from Teltonika office or distributors.
Only with these batteries correct device operation and (or) prevention of permanent damage to device
is guaranteed.
Warning: use only the same sort of batteries in pair and do not mix old batteries with new ones.
Note:
In order not to discharge the batteries, please remove them if not using the
device. After inserting new batteries to the device, please remember to reset the battery
level counter in the configurator. If new batteries are not inserted, do not try to reset this
counter (more details about the battery level counter are described in user manual documentation).
9
Summary of Contents for AT1000
Page 1: ...AT1000 User Manual V1 3 ...