Telsyco Sirius 2, User Manual

Page: 10 / 11

9
Table of SMS commands
identif. par. command body example description SMS reply Note
ALARM 1 to 8 , phone number )
1
42060212311 adding or change of phone number at positioni par. "OK"
ALARM 1 to 8 , ALARM2, erasing phone number on position par "OK"
ADMIN phone number )
1
ADMIN,+42060212311 adding or change of phone number ADMIN "OK"
ADMIN erasing phone number ADMIN "OK"
#1111#POLOHA #1111#POLOHA request for identification of position position
PERMIT,DDMM,ddm , DDMM,ddmm PERMIT,3105,0206 permission for data access for 1 hour to memory of recorde
d position . For transmission will be selected period betwee
n dates DDMM and ddmm
"OK"
CAR , OF CAR,OF deactivation of unit ( unit react then for SMS "STAT" and "
CAR,ON" only from ADMIN number
"OK" ADMIN only
CAR , ON CAR,ON unit activation "OK" ADMIN only
BLOCK , ON BLOCK,ON closing of output for blocking (switch off ignition)
for closing must be valid position reading and speed under
15 km/h
"OK"
BLOCK , OF BLOCK,OF unblocking "OK"
RST RST unit restart "OK"
STAT STAT identification of unit status programm version
ABCDE
Backup=x.xxV
Battery=yy.yV
Mode act
Block on (Block of)
credit
A=blok (1 ON)
B=key (1 od.)
C=alarm (1 on)
D=GPS (0 -off)
E=ignition
ALTIM , tt*bb*pp*uu 05*10*02*35 Remote setting of unit parametres "OK"
parametres in
previous table
CAL , ATD603123456
;
CAL,ATD603123456
;
unit generate a call to set number immediatelly after receivi
ng )
2
"OK" - call established
"NO CARRIER" - unreachable
"BUSY" - busy
CAL , ATH CAL,ATH zaøízení ukonèí probíhající hovor
CAL , AT+CPAS CAL,AT+CPAS identification of unit status "+CPAS: 0" - stand by
"+CPAS: 3" - incoming call
"+CPAS: 4" - current beying call
CAL , AT+CSQ CAL,AT+CSQ identification of signal strength "+CSQ: 17,99" - first number befor
e comma is signal strength(max 32
), min. value for calling is cca 17
CAL , AT+CPBR=par. CAL,AT+CPBR=1 identification of phone number on the SIM at certain positio
n par.
+CPBR: 1,"+420602123111",14
5,"ALARM1"
CAL , AT+CCLK=? CAL,AT+CCLK=? clock status in unit +CCLK:“00/01/01,01:17:36” )
3
because clocks are set to 0 when u
nit is switch off , running since 1.1.
00. It always shows operation time
since last switch off ( short fails are
not registrated)