Telstra Telstra 7300, User Manual

Page: 25 / 39

48 49
Calling Number Display
If you subscribe to Telstra’s Calling Number Display service, you can see your caller’s number on your
handset display prior to answering the call.
If the caller’s name and number are stored in the Phonebook and a name/number match is found, you
will see the caller’s name on the display instead.
It may take a couple of seconds for the display to show the telephone number (or name if stored in the Phonebook) for an
incoming call. The display will initially display
External Call
followed by the number. To ensure that the caller’s name
is displayed, make sure you have stored the full number including the area code in the Phonebook.
Caller information not available
For some incoming calls, the telephone number of the caller is not available and so cannot be
displayed. In this case the Telstra 7300/7300a provides you with some explanatory information.
Unavailable
– The number is unavailable. May indicate that the call is from overseas or from a caller
whose carrier does not participate in Calling Number Display.
Private
– The caller has withheld (blocked) their number or the call is from a Silent Line or unlisted
number.
Calls List
When a call is not answered, the display shows
New calls
and your caller’s telephone number will
be stored in the Calls list.
The Calls list holds up to 10 missed calls.
When the Calls list is full, the oldest call will be replaced by a new call, the most recent call will always
be at the top of the list. If a caller rings again their number will move to the top of the list.
Base settings
Restore default settings
You can reset your Telstra 7300/7300a base to its default (original) settings.
1. Press 8PY` to open the main menu.
2. Press
.LWW^
or until the display shows
Setup base
and press 8PY` .
3. Press
.LWW^
or until Reset is displayed, press 8PY` to select.
4. Enter PIN is displayed. Enter the 4 digit PIN code using the keypad and press 8PY` .
5. Reset? is displayed. Press 8PY` to confirm, Saved is displayed.
6. Press and hold
8`_P
to return to standby.
PABX access
If your Telstra 7300/7300a is connected to a PABX, you may need to enter an access code (e.g. 9) to get
an outside line. You can store the access code in the base so that all handsets registered to your Telstra
7300/7300a will dial the access code automatically before each number.
1. Press
8PY` , scroll
.LWW^
or to
Setup base
and press 8PY` .
2. Scroll
.LWW^
or to
Access code
and press
8PY`
.
3. Enter the access number and press 8PY` .
4. Press 8`_P to return to standby.
The access code only applies when you dial using the keypad. It will not be automatically dialled when using the
Phonebook, therefore it is recommended that you enter the PABX access code at the start of all Phonebook entries.