* Emergency stop: see chapter 2.1
9
Fig. 2-8
Fig .2-9
Fig. 2-10
2.10
SPECIAL INSTRUCTIONS FOR AUTO WRAP 1510 / 1514 TWIN
These machines must be prepared for transport in a slightly different way:
1.
Move the main wrapping arm in under the davit in the transport position by pressing
"STOP" (9)
and keeping it pressed in.
2.
For locking and disengaging the wrapping arm during transportation, ensure that the locking
bolt for the wrapping arm is fitted. (See section 2.6 and fig. 2-7.)
3.
Loosen the fixing screws for the locking plate which secures the second wrapping arm in
the working position. Then swing the arm in towards the davit. (See fig. 2.8.)
4.
To reduce the transport width of the TWIN machines, at the same time preventing the
secondary arm from accidentally swinging out to the side during transportation (see fig. 2.9),
each cutting beam is put in the transport position by holding the beam by the edge and
lifting it upwards and inwards by hand. Using a special grooved slot at the back end of the
mounting point, the cutting beam locks automatically in the raised transport position when
the beam is dropped to its lower position once more at the back. (See fig. 2.10.)
(
See also
sections 3 to 8 for the standard machines)
