SL869-3DR Evaluation Kit User Guide
1VV0301266 r0
2016-11-14
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights
Reserved.
Page 21 of 35
Mod. 0810 2011-07 Rev.2
5.2.
Computer Setup and Connection
Before operation, ensure that the EVK power switch is in the OFF (down) position and the
USB drivers are installed by performing the following steps:
1.
Insert the USB flash drive and connect the EVK to the PC via the USB-1 connector on the
rear of the EVK. Then, turn the Power switch vertically UP to turn On the EVK.
2.
As soon as the evaluation board is connected to the PC, it will be detected and the USB driver
installed.
3.
Note: If a software Installation warning appears select “Continue Anyway” option.
Figure 5-1 Hardware Installation Warning Screen
4.
After the EVK is connected, check the “Device Manager” window for the evaluation board
COM port number. This information is needed for use with the GPS tools.
5.
Connect the provided Active Antenna to the SMA connector.
NOTE:
On some occasions, Windows will install a Microsoft Serial BallPoint mouse after connecting
the USB. Uninstall the Microsoft Serial BallPoint mouse if Windows mistakenly installs it.
