SE873 Family Product User Guide
Safety Recommendations
1VV0301216
Rev.4
Page 66 of 69
2018-08-24
17. SAFETY RECOMMENDATIONS
READ CAREFULLY
Be sure that the use of this product is allowed in the country and in the environment
required. The use of this product may be dangerous and must be avoided in the following
areas:
•
Where it can interfere with other electronic devices in environments such as hospitals,
airports, aircraft, etc.
•
Where there is risk of explosion such as gasoline stations, oil refineries, etc. It is the
responsibility of the user to enforce the country regulations and specific environmental
regulations.
Do not disassemble the product. Evidence of tampering will invalidate the warranty.
Telit recommends following the instructions in product user guides for correct installation of the
product. The product must be supplied with a stabilized voltage source and all wiring must
conform to security and fire prevention regulations. The product must be handled with care,
avoiding any contact with the pins because electrostatic discharges may damage the product
itself.
The system integrator is responsible for the functioning of the final product; therefore, care must
be taken with components external to the module, as well as for any project or installation issue.
Should there be any doubt, please refer to the technical documentation and the regulations in
force. Non-antenna modules must be equipped with a proper antenna with specific
characteristics.
The European Community provides directives for electronic equipment introduced in the market.
Relevant information is available on the European Community website:
http://ec.europa.eu/enterprise/sectors/rtte/documents/
The text of the Directive 99/05 regarding telecommunication equipment is available, while the
applicable Directives (Low Voltage and EMC) are available at:
http://ec.europa.eu/enterprise/sectors/electrical/
The power supply used shall comply the clause 2.5 (Limited power sources) of the standard
EN 60950-1 and shall be mounted on a PCB which complies with V-0 flammability class.
Since the module must be built-in to a system, it is intended only for installation in a RESTRICTED
ACCESS LOCATION. Therefore, the system integrator must provide an enclosure which protects
against fire, electrical shock, and mechanical shock in accordance with relevant standards.
Summary of Contents for SE873 Series
Page 1: ...SE873 Family Product User Guide 1VV0301216 Rev 4 2018 08 24...
Page 69: ......
