Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 116 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 116 2019-08-05
5.3.6 Disassociation
This command is used to disassociate the current infrastructure network or stop the limited
AP created by the node. It is also used to disconnect P2P mode.
Command Syntax AT+WD
Synchronous Response
Table 90, page 116 describes the synchronous responses and remarks for the Disassociation
command.
Asynchronous Response
Table 91, page 116 describes the asynchronous responses and remarks for the
Disassociation command.
Example
AT+WD
OK
5.3.7 Connection Maintenance
5.3.7.1 Keep Alive Timer
This command is used to keep-alive the timing intervals associated with the GS node. This
keep-alive timer will fire for every n seconds once the GS node is associated. This timer
will keep the GS node in associated state even when there is no activity between AP and
GS node.
Command Syntax AT+PSPOLLINTRL=<n>
Parameter Description
Table 92, page 117 describes the Association Keep Alive Timer parameters.
Table 90 Disassociation Synchronous Responses
Responses Remarks
OK Success
Table 91 Disassociation Asynchronous Responses
Responses Remarks
314Dissassociation Event AP resets or connection to the AP is lost.
NOTE: This command is obsolete and it is retained for backward compatibility. It
is recommended to use AT+WKEEPALIVE command.