Telit Wireless Solutions BlueMod+S42M, Hardware User'S Manual

Page: 34 / 48

S42M Hardware User Guide
1VV0301379 Rev. 4 Page 34 of 48 2018-11-28
9.4.4. FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
9.4.5. FCC RF-exposure Statement
The S42M complies with the FCC/IC RF radiation exposure limits set forth for an
uncontrolled environment.
The output power is < 10mW EIRP
and therefore according to “FCC OET KDB 447498 D01
General RF Exposure Guidance v05” Appendix A, table “SAR Exclusion Threshold”,
excluded from SAR testing for test separation distances
≥
5mm and if it is not used in co-
locations with other antennas. If the product implementing the S42M has other
antennas in co-location or separation distances < 5mm, a MPE has to be re-evaluated.
9.4.6. FCC Labeling Requirements for the End Product
Any End Product integrating the S42M must be labeled with at least the following
information:
This device contains transmitter with
FCC ID: RI7-S42M
IC: 5131A-S42M