12
3.6
Closing the device
Please take care that the housing covers fit together tightly and properly, and that the rubber
gasket is still in place.
With the cover in place re-insert and tighten down all the screws. Be careful not to over tighten the
screws as it will damage the casing and could lead to a reduction in the effectiveness of the
environmental protection of the housing.
Please close the housing by screwing the Phillips screws down back into its original position. The
clear plastic light guides must be located above the LEDs. Please ensure that the cover locks
properly into position.
Min. torque M = 1,2 Nm
Max. torque M = 1,5 Nm
3.7
Status indicators
Internally the device has three status indicators; each indicator has 2 or 3 different coloured LEDs
grouped close together.
Components
Picotrack Endurance Primary / Rechargeable
Right indicator (GPS)
This indicator includes 3 LEDs under its glass (yellow, green and
red) and reflects the status of the GPS reception as well as the
device reset.
off:
GPS is not switched on
1 time blinking yellow
position acquisition not possible
2 times blinking green
2D-Fix (no valid height and the
position may be imprecise)
3 times blinking green
3D-Fix (GPS data are complete)
About 5 seconds red during device reset (in this case also the red
LED of the middle indicator is on at the same time).
Middle indicator
The middle indicator consists of two LEDs (yellow and red).
Yellow LED is permanently on
: this indicates that the device has
external power supply and the battery is currently charging (only
applicable for Picotrack Endurance Rechargeable). If the device is in
sleep mode, the middle indicator works identically; just the left and
the right indicator are off.
Remark: If the middle LED is off, this does NOT mean, that the Telic
Picotrack tracking and tracing module is switched off. In fact it only
indicates that the device is not connected to external power
supply.
The
red LED
indicates the following:
This one and the red right indicator are permanently on during the
