Teli CS3920, Operation Manual, Page: 12 / 20

6
(3)Shutter Speed (SW1 DIP4, 5&6) (Initial-Factory-Setting: DIP4, 5&6 OFF)
DIP4 DIP5 DIP6 Shutter Speed
OFF OFF OFF 1/30s
ON OFF OFF 1/60s
OFF ON OFF 1/125s
ON ON OFF 1/250s
OFF OFF ON 1/1000s
ON OFF ON 1/2000s
OFF ON ON 1/5000s
ON ON ON 1/10000s
(4)FLD Output / FRM Output Selection (SW1 DIP7) (Initial-Factory-Setting: OFF)
OFF: Field output
ON: Frame output
Under OFF (= FLD) setting, only the 1st field data is output in response to one trigger
input. Under ON (= FRM) setting, both the 1st and 2nd field (=1 frame) data are output
in response to one trigger input. Under the FRM output setting, CCD exposure is done
twice inside the camera. This causes 1-field timing delay.
(5)RTS (Random Trigger Shutter) Pulse Control
The camera starts light-exposure at the TRIG signal falling-edge timing. The
exposure-time is determined by pulse length. Be sure to set the pulse interval longer
than 1H (approximately 103
μ
s). The TRIG interval should be set longer than 2V
(approximately 133ms).
T = Exposure Time ＴＲＩＧ ＩＮ
Ｔ