1.
ON/OFF & Volume Control
– Turns the beltpack power on and controls
headset volume.
2.
WTA Button and Light
– Wireless talk button. When pressed, the user’s
audio is disconnected from the wired intercom at the base station.
3.
SA Button and Light
– Wireless talk button. When pressed, the user’s
audio is routed to the stage annouce connector on the back of the base
station. The user also loses their sidetone as an indication that stage
announce is activated.
4.
Audio Channel Select Button and Lights
–Allows the user to select either
audio channel 1 or 2.
5.
BAT/O.M. Light
–
Battery -
Light flashes on power up = Battery OK
Light on continuously = Battery Low
Light does not flash or come on = Battery Dead
Microphone Lvl: Light flashes on loudest speech = Gain OK
Light flashes on all speech = Gain too High
Light never flashes on loudest speech = Gain too Low
6.
Talk Light
– LED is on when the talk button, SA or WTA is active.
7.
Talk Button
– Press to enable the audio path from the headset.
Software Selectable modes: Push-to-Talk
Push-to-Latch
Controls and Connections
1.
[MENU] and [SET] buttons
– Used to select menus and set options
on the LCD.
2.
LCD display
.
3.
[UP] and [DOWN] buttons
- Used to select menus and set options on
the LCD.
4.
Programming Connector
– Used to update flash in unit.
5.
Headset Connector
– XLR Plug for Telex units, XLR Receptacle for
RTS units.
6.
Battery Latch
– Press down to enable the battery pack to be released.
While the latch is held down, slide the battery pack about 1/8 inch
back, toward the latch, until it stops, then lift out.
7.
Receive Antenna
– The antennas are screw type, ¼ wave, replaceable
antennas. The color dot on the screw end of the antenna must match
color dot on antenna receptacle.
8.
Transmit Antenna
– The antennas are screw type, ¼ wave,
replaceable antennas. The color dot on the screw end of the antenna
must match color dot on antenna receptacle.
Page 2 of 3
