VDSL2 Manual
6
Front Indicators
LED Description and Operation
The Modem has three LED indicators.
LEDs
Status Descriptions
PWR
(
Ready LED
)
Steady
Green
It will light up (ON) to show that the product is
power good, and system reset OK.
1~4
(
Ethernet LED
)
Steady Green
Flashing (LINK/ACT)
Each RJ-45 station port on the Ethernet is assigned an LED light
for monitoring port “Good Linkage”. LED is normally OFF after
the power on operation, but will light up steadily to show good
linkage and flashing to show data transmission.
WAN
(
VDSL LED
)
Steady Green
RJ11 station port on the VDSL is assigned an LED light for
monitoring port “Good Linkage”. LED is normally OFF after the
power on operation, but will light up steadily to show good
linkage.
Rear Panel
The following figure shows the rear connectors
Figure Chapter 3.3 Rear Connectors
VDTU2-104&CPE MODEM Rear Connectors
Connectors Description
Type
Line
For connecting to the VDSL Modem Using
a RJ-11 cable
RJ-11
Phone
For connecting to the telephone or Fax
、
ISDN Modem RJ-11
E1~E4
For connecting to a Ethernet equipped device
RJ-45
Console port
For connecting to PC with RS-232 serial
port over a D-SUB Cable
RS-232
Power On
1. Check the adapter is properly connected.
2. Verify the power LED is steadily on.
