Televes TOX Series, User Manual

Page: 14 / 32

COFDM - COFDM CI
14
5.1. Normal menu
a. Input menu
The fi rst main menu allows you to select for the
input signal: the
frequency or channel , the off set
( channel mode only), the bandwidth and the
preamplifi ers powering .
INPUT
Freq:666.000
Bw: 8MHz
Preamp: 12V
INPUT
Ch:C45
Bw: 8MHz
Preamp: 00V
To make a change press the key until the desired
parameter fl ashes. Then, this fi eld can be changed
by means of the keys and .
You can select any output frequency value between
177,5 - 226,5 MHz (VHF) and 474-858 MHz (UHF).
The decimal part depends on the frequency step
selected (
see extended menu b ). If the frequency
step is defi ned as 125KHz, decimal part values
allowed are: 0, 125, 250, 375, 500, 625, 750 and 875
KHz. If it is a 166 KHz step, then the values allowed
are: 0, 166, 333, 500, 666 and 833 KHz.
Possible COFDM Bandwidths are: 7MHz or 8MHz.
Available voltages to power preamplifi ers are: 0, 12
and 24 Vdc
In the case of a shortcircuiting condition in the
5. - Instructions for use
Insert the programmer in the front connector of
the module (“PRGM”). First, the programmer’s
fi rmware version will appear:
PCT firmware
version
------------
V:5.03
The fi rmware version of the COFDM – COFDM CI
module is shown below:
Unit
Firmware
version:
1.01
input connector (line power set to ON) the frontal
LED will be blinking until it is fi xed.
b. Output menu
The next main menu shows the frequency or
output channel , the output off set (only in channel
mode), the level control and the selection of
output mode .
OUTPUT
Freq: 474.000
Bw: 8MHz
Lev:99 Norm.
OUTPUT
Ch:C21 Of:0
Bw: 8MHz
Lev:99 Norm.
To change the frequency press the key until the
desired parameter fl ashes. Then, this fi eld can be
changed by means of the keys and .
In frequency mode you can select any output
frequency value between 177.5 - 226.5 and 474 -
858 MHz. The decimal part depends on the step
of frequency chosen (
see extended menu b ). If you
select a steps of 125 KHz the permitted values for
the decimal part are: 0, 125, 250, 375, 500, 625, 750
and 875 KHz. With a steps of 166 KHz the possible
values are: 0, 166, 333, 500, 666 and 833 KHz.
In channel mode you can choose an output