Televes T.0X 565301, User Manual

Page: 17 / 48

EN
17
The configuration screens are organized in three
main sections as shown in the figure (refer to
Appendix 4 for a detailed diagram):
• Section A: MAIN (TRANSCODER) MENUS
• Section B: CONFIGURATION (COMMON) MENUS
• Section C: MONITORING MENUS
LEDs A, B and C will light up indicating the currently
selected section.
The
■
button toggles between sections.
To move up and down a section press the
▲
and
▼
buttons .
To save data, press and hold the
■
button.
In each individual screen, pressing the
●
button
enables the “Edit mode” and the selected
parameter can then be modified by using the
▲
or
▼
buttons.
In those cases where the cursor may be placed
in more than one position (for example an input
frequency with several digits) press the
●
button as
many times as needed to position the cursor over
the desired field.
To move to a different screen, press the
●
button
until the cursor stops blinking (cursor is OFF,
leaving “Edit mode”).
8. Instructions for use
PCT UNIVERSAL
A B C
The first item displayed after
connecting the Programming Unit
to the front of the transmodulator
is the Programming Unit’s firmware
version:
PCT firmware
version
------------
V:5.03.00001
Sub-menu 1
Sub-menu 2
Sub-menu N
▲
▼
Sub-menu 1
Sub-menu 2
Sub-menu N
▲
▼ ▲
▼
Sub-menu 1
Sub-menu 2
Sub-menu N
8.1 - MAIN menu (LED A is ON)
Transcoder selection
The first menu allows the selection of one of the
unit’s tuners, A or B. Once selected, the remaining
submenus in this section will refer to the
parameters of the selected tuner.
SELECT
TRANSCODER
TUNER A
SELECT
TRANSCODER

TUNER A

Press the
●
button to enter “Edit mode” so the last
line of the display starts to blink (cursor ON). You
can now select one of the tuners (A or B) using the
▲
and
▼
buttons. To exit “Edit Mode” press the
●
button until the cursor stops blinking (cursor OFF)
An indication of the input and output status is
provided in each sub-menu of section A (main
menus). The top leftmost character will be “•” if the
input is locked and “-” otherwise. Similarly, the top
rightmost character will be “•” when the output is
locked and “-” otherwise.
Input frequency/channel selection
Use this menu to select the input frequency/
channel according to the mode selected in the
corresponding CONFIGURATION menu.
The display will show the following information in
each case: