Televes Common Interface 7254, User Instructions

Page: 42 / 60

User instructions “Common Interface”
42
Antenna Setup
If each of Antenna Setup menus is selected, a changeable value will appear
at the right side of the screen.
To change to the desired value, use the LEFT/RIGHT buttons.
Move the cursor to the right side of the screen using the RIGHT button. Then
select the desired value using the UP/DOWN buttons, and press OK button.
1.- Antenna Setup:
Select your antenna number. You can select maximum 32 antennas.
2.- Satellite:
Select a satellite you want.
3.- Transponder:
Select a transponder you want.
4.- LNB Power:
Select a LNB Power On or OFF.
5.- LNB Type:
Select your LNB Type.
6.- 22KHz:
Auto.
7.- Switch Type:
Select your switch type.
(None, DiSEqC, Motor, USALS)
- None
- DiSEqc : If your antenna has connected to the DiSEqC 1.0, select the
Switch type of DiSEqC.
- Motor : If you connect a DiSEqC 1.2 antenna to the receiver, select
the switch type to Motor. You can change position of your
Motor through the Option.
- USALS : You can select the DiSEqC USALS system, if it exists.
8.- Option:
Options vary according to the type of DiSEqC.
Select an appropriate option.
- DiSEqC : You can select and use appropriate port for your DiSEqC
switch box. (DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D.)
Select the command by pressing the UP/DOWN buttons.
After selecting all necessaries, press RED button.
Scan Satellite screen will be displayed on the screen.
9.- 0/12V:
Activate or desactivate the 12V option on RCA output