Televes
®
29
Keep in mind that the mitigation process is reducing the transmission
power of the devices and their sensitivity with consequent loss rate and
coverage. This option allows both networks to obtain best rates provided
the coverage thereof is not excessive and a decrease in transmission
power will not cause a decrease in link quality.
This adjustment process uses an iterative algorithm can have a
convergence period of about 17min, so keep this in mind when you
restart the device. This period is so long due to the fact that the system
must distinguish between noise inherent and/or transients in the
transmission line network transmissions causing interference nearby
permanent.
Factory Defaults Button
This option allows you to disable the front button that resets the device to factory settings.
Use is limited to cases where the installer wants
CoaxManager configuration not be deleted by the
client when press the button.
This option increases product security, when
disable factory button it is impossible to use it to
delete user settings when press.
Although button is disabled, the Factory Default option on
CoaxManager through GUI interface is still running and you
can set the factory settings by cliking button on
application.
Advanced Power Management
This option enables the low power mode on the device, allowing greater energy efficiency. The low
power mode is activated when no device connected to the host, or when even if there is connection to
PC not transmit data over a long period. The following table shows the energy savings achieved when
activated low power mode
Power
CoaxDATA 200Mbps
(Watts)
Power
CoaxDATA 1Gbps
(Watts)
Normal Power
4.5Watts
6Watts
Low Power
(Advanced Power
Management)
1.8 Watts
1.8 Watts
This option is only available on HomeNetworking mode and firmware versions that support it. In MDU
mode this option is not available since some programs like AccessControl™/CoaxManager™ not
function correctly when trying to connect to a remote device.
