1. Remove all items from packaging and check off against the parts list on page 2
2. Make a connection from the CATV or TV aerial wall outlet to the ‘CABLE IN’ connector
on the back of the EOC04, using the cable that was originally connecting the wall
outlet to the TV or Set top box
NOTE
: depending on the type of connector, it may be necessary to use on of F to IEC
adapters (see parts list Page 2)
3. Make a connection from the ‘ LOOP OUT’ port on the back of the EOC04 to the TV or
Set top box - this enables the TV signal to still pass to the TV or Set top box.
NOTE
: There is no Ethernet over Coax signal on the ‘LOOP OUT’ port so units cannot be
daisy chained together.
4. Make any connections to Ethernet devices using the supplied Ethernet patch cord.
5. Insert Power cable into EOC04 and switch on at wall
6. The EOC04 will take 10-15 seconds to power up and stabilise
Red Power light - unit is on and functioning
Yellow Coax Light - connection has been made to another EOC device on the network
and the EOC04 is receiving Ethernet Data
Green Wi-Fi indicators - EOC04 is transmitting Wi-Fi signals
Local Ethernet connection lights
Green – EOC Ethernet port is connected to Gigabit Ethernet device
Red – EOC Ethernet Port is connected to 100 Base T Ethernet device.
NOTE
: these lights only indicate local connection status and do not indicate that Gigabit or
100 Base-T Ethernet is being sent over the Coax.
7. Setup Wi-Fi SSID and Password - See next Section
Setup and Configuration procedure
Cable TV wiring
8