How to modify ATM Interface
Select the ATM interface from the Interface list (see picture 16
and click modify to modify ATM interface. The following
“
Modify Interface
” window appears on the screen (see picture
17). Set required values to
IP address
,
Subnet mask
and
hardware address
fi elds and click OK to continue. Enable
the ATM interface by ticking the checkbox “
Enabled
”.
How to add/modify IP Route
Click Add to add new IP Route or select the IP Route
from the IP Routes Interface list (see picture 16). Click modify
to modify IP Route. The following “
Add/Modify IP Route
”
window appears on the screen (see picture 18). Set required
values to
Network Destination
,
Subnet mask
and
Gateway
fi elds and click OK to continue.
DVX Busmaster checkbox
Not used.
Aal5 crc32 check checkbox
ATM checksum calculation, normally not used.
All changes in settings should be confi rmed by
pressing Apply .
Picture 17
.
Commander’s “Modify (ATM)
Interface” view.
Picture 18
.
Commander’s “Add/Modify IP
Route” view.
22 IND1x1 Series User Manual rev001