- 9 -
Reception of commercial station
Since the transmission speed of a commercial station is usually 50 bauds, adjust the speed accord-
ing to the section of the adjustment.
The shift width is normally more than 170 Hz, and the MONITOR LED lights up from the low beat
pitch side as shown below:
Goes out
Flickers
Lights
Flickers
Goes out
|
←
→
|
(continued light
at mark)
portion for shift
width
light up at
space
Since this set is of single side system, it can be used regardless of the shift width.
Turn the dial of the receiver to adjust to the first flickering point.
RTTY exclusive use switch
U.O.S. Unshift on-space (After receiving a space signal, the set automatically returns to the lower
case (character side).
If LTR signal is likely to skip due to interference or QSB, when this switch is turned on, the set
changes to the character side when a space signal is fed.
CONNECTABLE PRINTERS
Any printer of Centronics compatible parallel interface specification can be connected to this set.
The connector signals names for the printer in this set are as follows. Connect the printer by
matching the signal names.
Connection of external terminals or CW HAND KEY
