- 11 -
Adjust of RF OUT frequency
This set is adjusted according to the CCIR European standard VHF ch 4 (62.25 MHz). If fine ad-
justment is necessary, turn the core of RF coil.
Frequency increased.
Frequency decreased.
Coil
In the Australian specifications, the set is adjusted to VHF ch 1 (57.25 MHz)
CHANGEOVER
Changing method when using video monitor TV instead of home TV
Changing from RF OUT to VIDEO OUT
Cut and bridge with solder at two positions:
1. RF OUT selector part: Cut "R" - short "V".
2. RF converter part: Cut "RF -VIO".
Cut and short correctly by referring to the parts layout chart.
VIDEO OUT specification
Composite video signals (video normal modulation, synchronous negative modulation,
1.0 ± 0.2 Vp-p, 75 ohms).
Initial start changeover of Baudot, ASCII
The set is initially set to start in Baudot at the time of shipping. To start in ASCII, however,
bridge the [MODE SEL A] with solder.
At this time, the following message is displayed in the bottom line of the screen:
<ASCII Code> 110 Baud
Changeover of display output CCIR system and NTSC system
The system is set to CCIR at the time of shipping. It can be changed to NTSC as necessary.
In this case, short the MODE SEL B [bridge land B] with solder.
Normal/reverse selection
The input of Baudot and ASCII is set at mark L at the time of shipping. It can be changed
to mark H.
Cut the MODE SEL REV [cut land REV].
