TELEMED UAB ClarUs, User Manual

Page: 13 / 46

TELEMED ClarUs User Guide, REV 4.0 2013.12.04
13
If the ultrasound scanner will be moved or left unused for a long period of time
without being switched on it is recommended that it be disconnected from power
supply. If a scanner is to be switched on, do not interrupt this while operating the
system and while the ultrasound software is being loaded. The time for this operation
is approximately 1 min.
To avoid the risk of electrical shock and fire hazard:

before using the probe, inspect the probe face, housing, and cable and do not
use the probe if the probe or the cable is damaged;

always disconnect the AC power supply from the system before cleaning the
system;

do not use any probe that has been immersed beyond the specified cleaning
or disinfection level;

inspect the power supply, AC power supply cable and electrical plug on a
regular basis to ensure they are not damaged;

only use accessories and peripherals recommended by TELEMED.
WARNING:
To avoid the risk of electrical shock do not open the cover of
device/blocks. There are no parts that you can repair yourself. In
case of dificulties please contact the TELEMED service department
or your nearest local authorized distributor.
2.2. Equipment protection
To protect your ultrasound system, transducer and accessories, please follow
these precautions:

excessive bending or twisting of electrical cables can cause a failure or
intermittent operation;

incorrect cleaning or disinfecting of any system part can cause permanent
damage, for cleaning and disinfecting instructions see the relevant chapter
below;

do not use solvents such as thinners/benzene or abrasive cleaners on any
parts of the system;

do not spill liquids on the system;

incorrect assembly or configuration and using an incorrect power source may
damage the system.
WARNING:
Ultrasound probes can easily be damaged by incorrect handling!
Failure to follow these precautions can result in serious injury and
equipment damage!
2.3. Biological safety
Observe the following precautions related to biological safety:

do not use the system if it displays erratic or inconsistent behavior;