Telegärtner DoorLine TM4, Operating And Assembly Instructions Manual

Page: 22 / 52

5
Configuration
22 / 52 DoorLine TM4
5.9 Change the PIN Code
In delivery status, the PIN Code for the configuration is "0000". To prevent the
settings of your DoorLine from being changed by unauthorised persons, you
should change the PIN Code as follows:
1. Enter the configuration mode (see chapter Entry to config-
uration mode [
} 19])
2. Actuate the hashtag button and star button on the tele-
phone
3. Enter configuration command "88" at the telephone
You will hear the neutral acknowledgement tone
4. Enter new 4-digit PIN Code
You will hear the neutral acknowledgement tone
5. Repeat new PIN Code
You will hear the positive acknowledgement tone
If changing of the PIN Code is not completed with the positive ac-
knowledgement tone, check whether the correct PIN Code was input
when you entered the configuration mode. This is not checked by the
DoorLine until the end of the complete procedure.
Changes to the configuration are only possible with knowledge of your
PIN Code. For security reasons, enter your new PIN Code in the config-
uration table (see Overview of programming table [
} 37]).