Telegärtner DoorLine TM4, Operating And Assembly Instructions Manual

Page: 19 / 52

Configuration
5
DoorLine TM4 19 / 52
5.3 Acknowledgement tones
During programming, you will be informed about the positive and negative ac-
knowledgement tones via the programming status.
Each note symbol corresponds to a beep:
neutral Key input is expected ♪
positive The programming has been accepted ♪♪
negative The programming has not been accepted ♪♪♪♪♪♪♪♪
5.4 Saving and ending configuration
To end the configuration, it is sufficient to hang up the telephone receiver. The
device then detects the end of the call automatically and saves the changed
configuration.
5.5 Information on the entry of call numbers
Input Effect
* Does not result in the selection of this character but rather a di-
alling pause of one second
** Results in one-time dialling of a "*" character
If you reach your desired telephone via the call number "**1",
you have to enter "****1" in the call number input of the Door-
Line
# The DoorLine generates a flash pulse of 100 ms
## Results in one-time dialling of a "#" character
5.6 Entry to configuration mode
For configuration, you have to call your DoorLine with a touch-tone dialling
telephone. The way you can call the DoorLine depends on the configuration of
your PBX system.
When the connection to the device has been established, you can start with
the configuration.