Revision Date | July 10, 2017 || Document Number | UM-E71-308-01 || Rev C
30 of 48
5.2 Maintenance Connectors
Two maintenance connectors are located on the front of the unit behind the maintenance door.
5.2.1 Connector Definition J10 USB 2.0 connector
The J10 connector is a female micro USB that provides a serial interface to both the SIB and the AP.
5.2.2 Programming Header
A four pin SIB programming header is located below the J10 connector. This programming header provides
an interface for programming the SIB bootloader.
5.2.3 Reset button
The reset button is located behind the maintenance door. Holding the reset button for 5 seconds, until the
power LED rapidly blinks, will factory reset the Aruba AP.
5.3 Status Indicators
5.3.1 AP Status
The CWAP has AP status indicators that are visible on the top (radome) of the CWAP and are be used to
indicate the AP status and activity. The meanings of these indicators are defined in Table 7 below.
Table 7: AP LED Operation
Indicator
Color/State
Meaning
System
Status
Off
CWAP Powered OFF
Green/Amber- Alternating
Device Booting; not ready
Green - Solid
Device ready
Amber - Solid
Device ready; power-save mode (802.3af PoE)
•
Single radio,
Green or Amber - Flashing
Restricted Mode;
•
Uplink negotiated in sub optimal speed; or
•
Radio in non-high throughput (HT) mode
Red
System error condition
Radio
Status
Off
CWAP powered off, or both radios disabled
Green - Solid
Bother radios enabled in access mode
Amber - Solid
Both radios enabled in monitor mode
Green/Amber - Alternating
One radio enabled in access mode, one radio enabled in
monitor mode
5.3.2 Power LED
Green: When AC is present and the CWAP has not detected a fault condition.
Red: When the CWAP has detected a fault condition.
Blinking: Power on self-test.
