Install HDD:
The HDD must be installed before the DVR is turned on. Please refer to Appendix #1 for
HDD installation instructions.
Connect cameras, monitors and external devices. Please refer to the section “1.5 REAR
PANEL” for connection, and Appendix#2 for pin configurations of the external I/O port.
NOTE:
Be sure the cameras are connected and power-supplied before the DVR is
powered on. Otherwise the DVR will not be able to detect N/P system automatically.
Connect the AC power cord to power adapter and plug into an electrical outlet.
The “Power” LED will be on as red.
Press the “Power” button. The “Power” LED will be on as green.
It takes approximately 10 to 15 seconds to boot the system.
Set the date and time on your DVR. Please
DO NOT
change the date or time on your
DVR after the recording function is activated. The recorded data will be disordered and
you will not be able to find the recorded file to backup by time search.
NOTE:
If users change the date or time accidentally when the recording function is
activated, it’s recommended to clear all HDD data, and start recording again.
Connect all the devices to construct a surveillance system.
5
Go to “MENU” mode, move the cursor to “DATE”, and press “ENTER”. The screen will show
the following options.
Please
DO NOT
change the date or time when the recording function is activated.
See “
2.1 GETTING STARTED
” at P.5 for details.
DATE
DATE
DATE
2006-MAY-12 16:18:43
FORMAT
Y-M-D
DAYLIGHT SAVING
ON
(MENU)
RECORD
TIMER
DATE
DATE
ADVANCE
NOTE:
The illustrated setting means: During the daylight saving time period (start from the 4
th
Sunday of
March, end on the 4
th
Sunday of October), the DVR system time will plus one hour.
DAYLIGHT SAVING
DAYLIGHT SAVING
START
4TH-SUN-MAR 01: 00: 00
END
4TH-SUN-OCT 01: 00: 00
ADJUST
01 : 00