3-1
TIENet
®
Model 350 Area Velocity Sensor
Section 3 Setup and Programming for the
Signature
3.1 Configuring the
System
To configure the Signature flow meter for operation with the
TIENet 350 sensor, press
MENU
(
) to access the top menu,
and select Hardware Setup. For all TIENet devices including the
350 Ex, select Smart Sensor Setup (TIENet).
3.1.1 Updating the Device
List
When the 350 is physically added to the system, select Perform
Scan so that the flow meter detects it. When the scan is complete,
the 350 appears in the list of connected devices, ready to be con-
figured with the steps shown in Figure 3-2 on the following page.
Note
From the Hardware Setup menu, “Configure” refers to defining
and selecting the parameters for each connected device.
The parameters that will appear for the 350 sensor are:
The name of any parameter can be customized by highlighting it
and pressing Enter (
) to display the character grid. Nav-
igate the grid using the arrow keys. Select characters with Enter
and clear characters with Delete (
).
350 Level
350 Temperature
350 Velocity
350 Velocity Signal
350 Velocity Spectrum
350 Vel Spectrum Ratio
350 Sense Voltage
Summary of Contents for TIENet 350
Page 2: ......
Page 4: ......
Page 43: ...TIENet Model 350 Area Velocity Sensor Appendix B Velocity Error Codes B 4...
Page 45: ...Warranty...
