15
AUSTRALIA & NEW ZEALAND DECLARATION OF CONFORMITY – EMC
The instrument complies with the EMC provision of the Radio Communications Act per the
following standards, in accordance with requirements imposed by Australian Communication and
Media Authority (ACMA):
AS/NZS CISPR 11:2015 Radiated and Conducted Emissions, Group 1, Class A.
Australia / New Zealand Contacts:*
RS Components Pty Ltd.
RS Components Ltd.
Suite 326 The Parade West
Units 30 & 31 Warehouse World
Kent Town, South Australia 5067
761 Great South Road
Penrose, Auckland, New Zealand
* Visit teledynelecroy.com/support/contact for the latest contact information.
Safety Compliance
EC DECLARATION OF CONFORMITY – LOW VOLTAGE
The instrument meets intent of EC Directive 2014/35/EU for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and
laboratory use –
Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control,
and laboratory use –
Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following limits put forth by these
standards:
• Mains Supply Connector: Overvoltage Category II, instrument intended to be supplied from the
building wiring at utilization points (socket outlets and similar).
• Measuring Circuit Terminals: No rated measurement category. Terminals not intended to be
connected directly to the mains supply.
• Unit: Pollution Degree 2, operating environment where normally only dry, non-conductive
pollution occurs. Temporary conductivity caused by condensation should be expected.
Environmental Compliance
END-OF-LIFE HANDLING
The instrument is marked with this symbol to indicate that it complies with the
applicable European Union requirements of Directives 2012/19/EU and 2006/66/EC
on Waste Electrical and Electronic Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that vary by country
and region. Many countries prohibit the disposal of waste electronic equipment in
standard waste receptacles. For more information about proper disposal and recycling of your
Teledyne LeCroy product, please visit teledynelecroy.com/recycle.