Teledyne Princeton Instruments Lansis, System Manual

Page: 19 / 101

Chapter 2 Lansis Camera System 19
EAR99 Technology Subject to Restrictions Contained on the Cover Page.
2.2 Cables
Table 2-3 describes the cables included with a standard Lansis Camera System.
2.3 Certificate of Performance
Each Lansis camera is shipped with a Certificate of Performance which states that the
camera system has been assembled and tested according to approved Teledyne
Table 2-2: Lansis Rear Panel LED Indications
LED Lansis system state
Green, solid No errors, camera is in standby (executing
cleans)
Off Acquiring-No errors, camera is in acquisition.
Yellow, Blinking The TEC heat sink is too hot, (hot ‐ side over ‐ tem ‐
perature error), the FPGA turned off the TEC Sup ‐
ply. This should allow the heat sink to cool.
If/when the heatsink cools enough, the FPGA will
set the LED back to green or off and re ‐ enable
the TEC supply.
Red, Blinking Critical Board Temperature (TEC remains driven).
This will automatically clear if the board tem ‐
perature goes down to an acceptable level.
Yellow, Solid
TEC power supply has a failure.
Red, Solid Other power supply has a failure.
Table 2-3: Standard Lansis Camera System Cables
Cable
Part
Number
Description/Purpose Length
USB 3 6050-0738 Connects the USB 3 connector on the rear of the
Lansis with the host computer. ~5 m
MCX to BNC 6050-0540 Three (3) MCX to BNC adapter cables are
included. These allow connection to the MCX
connectors on the rear of the Lansis using BNC
cables.. ~15cm
441
1-0
174_
0
00
4
44
11-
0
174
_0
00
5