Teledyne Kuro, Manual

Page: 40 / 48

40 Kuro sCMOS Camera System Manual Issue 2
3. Locate an available 4-channel or higher PCIe slot (marked x4.) Refer to the PC’s
documentation to locate a suitable slot.
NOTE:
The PC may have motherboard slot information on the side
cover.
See Figure E-3 .
Figure E-3: Typical Motherboard PCIe Slots
4. Holding the Kuro PCIe card and being careful not to touch the board’s components
or PCIe bridge pins insert it with the proper orientation into the open slot. The card
should slide into place with minimal resistance and snap when fully inserted.
5. Replace the cover on the host computer.
6. Boot the host computer.
E.2 Connect Kuro to the PCIe Bus
The Kuro sCMOS camera data cable, shown in Figure E-4 , is a quick insertion, quick
release cable that works with the interface card and camera. Either end of the cable can
be plugged into either device, and in any order.
Figure E-4: Typical Kuro PCIe Data Cable
4
4
11
-01
5
9
_0
005
4
4
11-
015
9
_00
0
6