Teledyne Kuro, Manual

Page: 17 / 48

17
Chapter 3: Install LightField
This chapter provides the installation procedure for LightField application software.
NOTE:
If LightField has already been successfully installed on the
host computer, this chapter may be skipped.
3.1 Prerequisites
Before beginning to install LightField, verify that:
• The host computer satisfies the minimum system requirements as stated in
Section 1.4, Minimum Host Computer Specifications , on page 9.
• The host computer includes a USB3 port;
If it does not support USB3, refer to the host computer manufacturer’s
instructions for installing a USB3 interface card;
• The installation disk and hardware key are available.
3.2 Installation Procedure
Perform the following procedure to install LightField on the host computer:
1. Insert the LightField Installation CD into the CD drive on the host computer, and
follow the on-screen prompts.
2. After the installation has been completed, reboot the host computer.
3. Connect the Kuro system components to the host computer and apply power.
4. Launch LightField, activate it, and begin experiment configuration.