Teledyne DALSA Piranha 2 P2-2x-01K40, User Manual

Page: 70 / 86

70 Piranha 2 User’s Manual
03-032-00493-14 Teledyne DALSA
Monitoring Task Message Codes
Code
Description Suggested Cause
32 WARN IN G: Line rate is set
below 1000 H z Exp osu re m od e 2: cu rrent line rate is below
1Khz
C6 Camera Parameter Screen
You can read cu rrent cam era settings w ith the
gcp
com m and . The table below lists the
settings d isp layed on the gcp screen w ith sam p le valu es, along w ith a d escrip tion of som e
of these settings:
GCP Screen Desctiption
GENERAL CAMERA SETTINGS
Camera Model No.: P2-xx-xxxxx Cam era m od el nu m ber.
Camera Serial No.: xxxxxxxxx Cam era serial nu m ber.
Camera Network ID: x Cam era netw ork id set
w ith the
sci
com m and .
Network Message Mode: disabled Disp lays w hether netw ork
m essages are enabled or
d isabled . Set w ith the
snm
com m and . See C4
N etw orking Mod e for
d etails.
Firmware Design Rev.: xx-xx-xxxxx-xx Firm w are d esign revision
nu m ber.
DSP Design Rev.: xx.xx DSP d esign revision
nu m ber.
SETTINGS FOR UNCALIBRATED MODE:
Analog Gain (dB): +0.0 +0.0 +0.0 +0.0 Analog gain valu e set w ith
the
sg
and
cao
com m and s.
Available only in
u ncalibrated m od e (
svm
0
).
See section 3.13 Setting
Gains for d etails.
Analog Offset: 308 324 304 292 Analog offset valu e set
w ith the
sao
and
cag
com m and . The
cag
com m and is available only
in u ncalibrated m od e (
svm
1
). See section 3.12
See the following section for
a complete command list.