1-1
340CF ELSD
Section 1 Quick Start Guide
This section provides information specific to connecting the
ELSD unit to a Teledyne Isco instrument. For general infor-
mation about installing the ELSD, refer to Section 3.2.
1.1 Connecting to the
Combi
Flash
® Rf200
The Combi
Flash
Rf200 uses RFID (Radio Frequency Identifi-
cation) technology to automate setting the parameters for purifi-
cation runs and fraction collection.
To connect the ELSD to the Rf200:
1. On the Rf, disconnect the tubing from ports C and D.
(Retain the tubing assembly in case it is needed again
later.)
Figure 1-1 Preparing the Rf200 connection ports
2. Connect the shorter tubing assembly to port C, and the lon-
ger tubing assembly to port D (refer to Figure 1-2).
3. Connect the other ends of the tubing to either side of the
tee fitting on the rear panel of the ELSD.
Disconnect
ports C & D
