Teledyne 3000ZA-3X, Operating Instructions Manual

Page: 36 / 72

Installation 3000ZA-3X
Teledyne Analytical Instruments 24
Figure 3-6: FET Series Resistance
3.3.2.3 RS-232 P
ORT
The digital signal output is a standard, full duplex RS-232 serial
communications port used to connect the analyzer to a computer,
terminal, or other digital device. It requires a standard 9-pin D
connector.
The output data is status information, in digital form, updated every
two seconds. Status is reported in the following order:

The concentration in ppm or percent
 The range in use (HI, MED, LO)

The span of the range (0-100 ppm, etc)

Which alarms—if any—are disabled (AL–x DISABLED)

Which alarms—if any—are tripped (AL–x ON).
Each status output is followed by a carriage return and line feed.
Three input functions using RS-232 have been implemented to
date. They are described in Table 3-5.