Teledyne 2103Ci, Installation And Operation Manual, Page: 28 / 74

2103 Modem Module
Section 2 Preparation and Installation
2-16
If your cellular service is set up and ready for use through your
service provider, you can now connect to your interface module
via cellular connection.
Note
For systems using the cellular modem, a Power Control
method is highly recommended to conserve battery power.
Refer to Section 2.8.
2.7 Setting Up Text
Messaging (2103Ci)
To program the 2103Ci for text messaging, you must have the
Short Message Service (SMS) server number or the Telocator
Alphanumeric Protocol (TAP) and the parameter settings of your
cell phones and/or pagers.
1. Make sure you are connected to the site, and select the
Alarms tab (Figure 2-13).
Figure 2-13 Setting up text messaging and alarm conditions
2. Under Alarm Notification, select the Alarm type (SMS or
TAP). SMS is recommended. (The TAP option has been
retained for legacy systems; you may be unable to obtain a
number or service.)
3. In the Phone Number list box, type the contact telephone
numbers. These must be valid SMS or TAP access num-
bers. You must enter at least one number; you can enter as
many as five. When an alarm condition is triggered, the
system will try dialing each number in the list.