Teledyne SP Devices ADQ7DC, Manual

Page: 12 / 50

19-2233 PC2
2019-02-01
12(50)
ADQ7DC Manual
16-1796 PC2 2019-02-01
12(50)
4 TRIGGER
4.1 Trigger block diagram
The digitizer can be triggered in various ways with a number of different internal and external trigger
sources. Selected events in the trigger module can also be output to trigger external equipment. The
selection of trigger source is illustrated in
Figure 3 .
# DESCRIPTION USER COMMAND REF
a Connectors for external analog input signals. The number of
channel vary on the different models and configurations.
b Each analog input is connected to a level trigger block. SetupLevelTrigger 4.9
c Select on which channel to trigger (when using level trigger). SetupLevelTrigger 4.9
d Internal trigger generator. SetInternalTriggerPeriod 4.10
e A software trigger is available for user control. SWTrig 4.6
f External trigger input from backplane in PXIe or MTCA. 4.8
g External trigger input on front panel connector TRIG. 4.7.1
h External trigger input on front panel connector SYNC. 4.7.2
i Select which type of trigger to activate. SetTriggerMode
j Activate trigger output. SetupTriggerOutput 4.11
k Select which channels to record data from. SetStreamConfig
l Acquisition engine creates a record from streaming data 7
m Records are sent to data FIFO for transfer to the host PC 7
n The trigger blocking function controls the flow of triggers to the
acquisition engine. SetupTriggerBlocking 4.4
o Note that the trigger output and the external trigger input are
physically the same connector on the front panel: TRIG.
p Frame sync is a function that can group triggers. SetupFrameSync 4.11.2
Figure 3: Trigger source selection and setup illustrated for a 2 channels mode.
()*
+#
, - ,-
,-
,-
.
/
"
,-
,- ,-
% &
+#
#
#
%
0)01
$
,2-
)
()*
"
/
/
,3-
,-
,-
45
2
"
,-
, -
,-
,-
/
/
0
2
"
/
/
% &
45
,-